 |
Measuring the wood strip to cut for framing the sides of the
canvas. |
In my
previous post, I showed you part 1 of my framing experiment. This time, I want to show you how I finished framing the piece. Top and bottom, the wood framing strips were cut and attached. To do the sides, I measured the length needed by laying the canvas on top of the wood strip and marking it. I'm going to cut two pieces that same length, one for each side, measured as shown in the picture to the left and below.
 |
| Lay the canvas on top of the length of wood. Measure, marks and cut with your saw. |
I used very small nails to attach the strips of wood. Even then, I found it easiest to make a starting hole with an awl to get the nail started. At first I did only top and bottom, but the canvas wasn't completely square, so I added a nail in the middle to eliminate any gaps.
When you cut the side pieces, top and bottom or side and side, remember to cut them the same size. Measure twice, cut once, but make them the same. Lightly sand the cut edges, mark your nail holes, and hammer the wood strips in place. Make sure you are hammering the nails into the wood edge of the canvas. I may use a drill and even smaller nails next time, as I did end up cracking the on one end of the framing strip as I hammered it into the adjacent piece.
After all the wood framing pieces were nailed in place, I painted them with transparent acrylic airbrush paint. It's very thin, so it's easy to paint on in layers to achieve the color you want. I used a golden yellow color to match the artwork without distracting from it. After the paint dried, I wired the canvas for hanging.
Hurrah, May Queen is ready to show!
 |
May Queen by Gayle Pritchard. The frame is attached
and ready to paint to match. The last step will be
wiring the canvas for hanging. |
 |
| Wired to hang |
 |
May Queen by Gayle Pritchard
Notice how the painted color of the frame doesn't
detract from the artwork. |
